OSET – Scout
TesTex has developed an innovative system for the detection of Corrosion Under Insulation (CUI) using our proprietary Off Surface Electromagnetic Technique (OSET).
The Scout system allows you to pinpoint the areas that require attention, instead of needlessly stripping insulation or doing thickness checks.
Advantages and Features
- One or two-man operation
- Portable all-in-one electronics with 10.1″ (257 mm) sunlight-readable touch screen
- AC or DC power
- A True scanning technique with high throughput
- Light-weight scanner design that fits most piping, vessels, and tanks starting at 2″ (50.8 mm) diameter piping and ranging up to flat surfaces
- Scans through stainless steel and aluminum cladding with insulation thicknesses up to 4″ (102 mm).
- Type of insulation (calcium silicate, mineral wool, fiberglass, etc.) has no effect on signal response. The presence of moisture within the insulation also has no effect
- Detects surface corrosion (wall loss, pitting) on piping of any wall thickness and large area I.D. corrosion on schedule 40 piping
- Can locate butt welds
- Encoded data with mapping option
- Multiple wheel sets and quick release pins on the axles allows the versatility of using only one scanner for your inspection needs
- Water Resistant
- Circumferential scanning technique on cladding overlaps to eliminate “reduced sensitivity/dead zones”
- Positioning device displaying circumferential position and reference angle to assure straight scans and angular position of the next scan
|Stainless Steel||up to 4″||up to 3″||up to 4″|
|Aluminum||up to 3″||up to 2″||up to 3″|
- Mapping Software
- Extra batteries/chargers
- 75ft.(23m) extender cable
- Specialty calibration pipes with specified defects (a standard pit calibration pipe and a welded calibration pipe is included with the system purchase)
Previous CUI Inspection Results
|4″ & 6″||Inspected approximately 10 piping circuits.
Detected wall loss on three (3) different pipes:
UT prove up confirmed wall thickness of 0.216″ of nominal 0.240″
|4″ – 16″||Inspected approximately 25 piping circuits. Identified area with wall thinning, and confirmed 0.418″ remaining wall thickness of nominal 0.500″.|
|6″||Inspected one piping circuit. Detected wall loss, of 0.417″ wall remaining of nominal 0.432″|
|2″ – 6″||Inspected 4 piping circuits. Detected several area of wall loss on one line. Customer did not want to “prep” line for UT prove up for fear of causing a leak.|